FLAME TREATMENT SYSTEMS

2 & 4 BURNER

Flame Treatment Systems

Ska Fab flame treaters are proven to provide a safe, consistent and reliable solution for effectively surface treating plastic bottles. Surface treatment systems are ideally suited to enhance the adhesion of bottle labels and printing prior to application.

Flexible adjustments and ease of operation enable maximum flame control on a wide range of container shapes and sizes. Built-in-safety features monitor container flow in and out of the flame area for product jams and line back-ups. Precision flow controls regulate air and gas for accurate flame and heat consistency. In addition, the unit is completely guarded for operator safety.

Reliable and repeatable surface treatment
Available in two or four burner configurations
Suitable for a wide range of container sizes
Built-in safety shut-off features

TECH SPECS

2 burner unit – single unimixer to supply gas/air to 2 burners
4 burner unit – two unimixers to supply gas/air to 4 burners
8″ adjustable flame burner heads for ease of adjustment for various treatment surface sizes (8″ to 4″ adjustable flame size)
Extruded aluminum frame and wire mesh guarding with dual interlocked safety doors located on both sides of unit to provide easy access to burner heads
Access doors on each side of the unit for easy access to burner heads
Frame designed to drop over existing conveyor
Adjustable for multiple bottle sizes
Photocell upstream to shutdown flame during bottle absence
Tool-less adjustability with numeric gauges. This allows for pin point accuracy, repeatability, consistent surface treatment, and quick and efficient bottle changeovers
4 burner unit – fully adjustable bottle rotator handles bottles that are short, tall, wide, narrow, round, square, off-centered necks, and more
Photo eyes monitor the flame treat areas for blockages or jams
Photo eyes mounted downstream monitor line for bottle back-up events
Bottle blow off for bottle back-up events
Visible stack light to warn of any blockages in the flame treat area

CONTROLS SPECS

Photo-eyes monitor bottle flow in and out of flame area
Flynn burner monitors flame faults
Photo eyes monitor the flame area for blockages and jams
Downstream photo eye to prevent backups into flame area
Optional bottle rotator speed selection and recipes are featured on the 4 burner touch screen

MOTOR SPECS

Conveyor drive 1/2HP
Conveyor speed – up to 70 ft/min
Optional bottle turner drive (1/8HP for 4 burner

UTILITY SPECS

Air supply: 80-100psi
CFH natural gas (ft 3/hr)
- 2 burner – 33CFH
- 4 burner – 66CFH
CFH propane (ft 3/hr)
- 2 burner – 13.5CFH
- 4 burner – 27CFH
Gas pressure – 0.28 psi min to 1 psi max (8″w.c. – 27″ water column)
Power supply – 120/1/60, 30 amps

2 & 4 BURNER

Flame Treatment Options

10” adjustable flame burner head (10” to 5” adjustable flame size)

12” adjustable flame burner head (12” to 6” adjustable flame size)

Stainless Steel Vent Hood

8’ section of 3 1/4” table top conveyor (no rails) includes flame retardant table top chain, brass wear strips, aluminum frame and variable frequency drive

Extended Frame Guards – 1 set (22” long)

ADDITIONAL OPTIONS

Brake paddle assembly (upgrade from air blow off)
Down bottle detection upgrade
Bottle break & bottle blow off options
Castors (set of 4)

FLAME TREATMENT SYSTEMS

2 & 4 BURNER